Finished basic partitioning of VZ61. Ugly, but there it is. There are four connecting sidewalls (one on each side, purple, red and teal pieces in the pictures below) which can be printed flat without supports. The rear buffer (yellow) can be printed on its backside without supports. I think the front piece can be printed without supports. Middle piece (green) is complex and definitely needs support and should be printed upright. The grip piece (blue) should slide in upward and will be pinned in place.
 |
| skorpar15_partioned_v0_90c |
Untested; not ready for distribution just yet. Soon, though (this year, sometime).
To do:
- Round out the rear connecting walls a little bit to be aesthetic and add material around screw holes
- Make the rear connecting wall follow the angled contour of the middle piece and mag well area.
- Triggergaurd - a single 3d printable one or an AR15 triggergaurd adapter
- Add pin holes on grip mount
- Add an optional buffer tube adapter
- Alternative versions for an AK grip or my custom MG42-styled grip.
 |
| Top view |
No comments:
Post a Comment